SEAT RULE

[Ray CS484]

Hi new seat mounts have no problems with safety rules a little more time might of helped the ax seat is bolted to the floor times 4 its back is resting on a bar. So to bolt it to this is ok it is the floor mount the front 2 bolts seam to go thru a structural part of the car but the back is bolted thru the floor with 4” washers.
Will I need to change this if so will welding flat bar or box from the innersil to the tunnel will this pass inspection.

Cheers Ray..

[hold on tight]

I'm not a scrutineer, but what you propose sounds alright to me. A couple of bolts through the seat, onto the bar behind it should be OK.
I think!!!! Sounds the same as what we have done.

Ian